Back To Black Bumper & Trim Restorer 500ml, Plastic & Rubber

1. What is Back To Black Bumper & Trim Restorer?

It is a specialised restorer and protectant designed to revive faded plastic, rubber, and trim surfaces, bringing them back to their original deep black finish.

2. What surfaces can it be used on?

It is suitable for bumpers, trim, side mirrors, door handles, grilles, and rubber seals on vehicles.

3. How does it work?

The formula penetrates and restores faded surfaces, adding a UV-resistant protective layer that helps prevent further fading, cracking, and discolouration.

4. How do I apply this product?

Clean the surface thoroughly to remove dirt and grime.

Apply a small amount of the product to a clean cloth or applicator pad.

Rub onto the trim using circular motions.

Buff with a dry microfibre cloth for an even, streak-free finish.

5. How long does it last?

The effects can last weeks to months, depending on weather conditions and washing frequency. Regular application maintains a long-lasting finish.

6. Is it safe for all colours of trim?

Yes, while formulated for black trim, it can also enhance dark grey and other dark-coloured plastics.

7. Can it be used on interior trim?

It is designed for exterior use, but it may be safe on certain interior rubber or plastic trims. Always test on a small, hidden area first.

8. Does it leave a greasy or sticky finish?

No, it dries to a clean, non-greasy finish that repels dirt and water.

9. Can this be used on painted surfaces?

No, it is specifically for unpainted plastic and rubber surfaces. Avoid contact with painted areas and glass.

10. How should I store this product?

Store in a cool, dry place, away from direct sunlight and heat. Ensure the bottle is tightly sealed after use.

Step 1 – Clean Thoroughly

Remove:

• Dirt
• Road grime
• Grease
• Wax
• Silicone dressing
• Existing trim treatments

A properly cleaned surface gives the most even result.

Step 2 – Allow to Dry

Apply only to clean, dry exterior trim.

Step 3 – Test First

Test a discreet area on:

• Older plastics
• Textured plastic
• Dark-grey trim
• Unusual rubber
• Previously treated surfaces

Step 4 – Shake Thoroughly

Shake the aerosol well before use and periodically during application.

Step 5 – Spray From 10–20cm

For larger suitable areas such as unpainted bumpers:

Apply evenly from approximately:

10–20cm

Avoid heavy application or excessive product build-up.

Step 6 – Precision Areas

For:

• Window rubbers
• Narrow trim
• Door handles
• Small mouldings
• Areas close to bodywork
• Areas close to glass

spray the product onto a clean cloth first and wipe over the surface.

This provides greater control and reduces overspray.

Step 7 – Allow to Dry

Allow the treatment to dry fully.

Avoid washing or heavy exposure until the coating has cured.

Step 8 – Reapply as Needed

Longevity varies according to:

• UV exposure
• Weather
• Washing frequency
• Cleaning chemicals
• Mileage
• Surface condition

Reapply when the restored appearance begins to diminish.

Step 9 – Clear the Nozzle

After use:

• Invert the aerosol
• Spray for approximately 2 seconds to reduce nozzle blockage.